Description:
HSPEED Short Shifter
Audi 80 90 Coupe Quattro Typ85 016 / 01E
Transmission selectable:
016 5 speed + 01E 6 speed
HSPEED SHiFT ENGiNEERiNG
HSpeed Short Shifter for Audi 80 90 Coupe Quattro Typ85 016 / 01E
Transmission: 016 + 01E
Gears: 5 + 6
HSpeed Short Shifter fits plug & play and is adapted to the original mounting points. Adaptation work on the tunnel is not necessary.
The HSpeed Short Shifter shortens and optimizes the shifting travel of the H-shift and thus promotes fast and precise shifting even under tension and load.
The pre-installed center position spring supports you when changing gears and at the same time stabilizes the guidance between the shifting lanes - for optimum feedback.
The positioning of the shift lever is designed for motorsport and for a very sporty rider, close to the steering wheel.
HSpeed Short Shifter offers you the option of using the adjustable gear stops to lock lower and higher gears (e.g. 2 or 5-speed) to prevent gear shifting during the ¼ mile drift or on a short racetrack.
The stops are also used to set the left/right movement and the reverse gear lock.
Reverse gear is actuated via the pull lever on the gear knob, which unlocks the reverse gear lock via a cable and releases the shift gate for reverse gear.
This prevents reverse gear from being engaged accidentally in race or absolute escalation mode. However, you can also use the lock to lock or unlock other gears to prevent shifting.
A preference for perfection and a master at the drawing board have resulted in perfectly coordinated components with a very high level of rigidity despite the low weight.
ATTENTION!
Hspeed Short Shifters are individually designed for each vehicle model and can only develop their full function in the corresponding vehicle type.
HSpeed short shifters, as well as all other products, are developed and built exclusively for motorsport!
For the conversion, you will need common tools and basic knowledge of vehicle technology.
Fairing parts must be removed
The original shift linkage can be used depending on the gearbox type
Information on the material
We only use 7075 aluminum (also known as aircraft aluminum) for the turned and milled parts.
The substructures are made of 3 mm thick aluminum sheet AlMg3.
We also use stainless steel for the smallest parts
Dimensions: Width: 12 cm | Height: 40 cm | Length: 23 cm
Included in delivery:
Pre-assembled HSpeed Short Shifter
Not included is the pictured shift rod
